technician a says that most v6s use offset connecting rods. technician b says that rods that have been resized must use oversized rod bearings. who is right?

Question

21-11-2022
Engineering

contestada

technician a says that most v6s use offset connecting rods. technician b says that rods that have been resized must use oversized rod bearings. who is right?

Respuesta :

Otras preguntas

Describe the orbital diagram of an atom with eight electrons. Explain how this orbital diagram demonstrates Hund's rule.

Shannon started a savings account by putting in $25. On the 1st week she deposited $15 and plans to continue depositing $15 each week. Given the graph, descript

A set P contains 22 elements. Another set C contains 5 elements. What is the maximum and minimum amount of elements for P and C?

kara interviews five drug users and discovers that four regularly carry weapons. based on this information, she argues that drug users are more likely to carry

If you were to mistakenly make the right turn, what are steps you should take to reduce the risk to yourself and others?

a red light flashes every 17 seconds a green light flashes every 15 seconds they both flash at the same time after how many seconds will they both flash at t

The following equations estimate the calories burned when exercising (source): Women: Calories = ( (Age x 0.074) — (Weight x 0.05741) + (Heart Rate x 0.4472) —

chapman chairs, a family-owned corporation, declared and distributed a property dividend from its overstocked inventory in place of its usual cash dividend. the

What early education tradition in America was inspired by German immigrants?

Which of the following best describes the characteristic a historian needs in order to speculate? in order to speculate. Since a complete knowledge of history i

arenasaleem890 arenasaleem890 · Answer 1 · 2022-11-26T13:58:00+01:00

The correct answer is Neither A nor B. therfore no technician is correct neither connecting rods nor the rod bearings says technician is right.

As the piston moves inside the cylinder, the connecting point between the second end of the rod and the crankshaft is sufficiently offset from the longitudinal axis to enhance engine torque and horsepower. Connecting rods can be made of a wide range of materials, including carbon steel, cast iron with spheroidized graphite, iron base sintered metal, and micro-alloyed steel. The connecting rods used in mass-produced car engines are typically constructed of steel.The crankshaft and connecting rod are held in position while rotating by an engine rod bearing, which is a split-sleeve type bearing (meaning it has two distinct semicircular half or shelves).

To learn more about connecting rods click the link below:

brainly.com/question/18365248

#SPJ4